The WFT 2 is the next generation of WFT trimmers. The two main improvements are the ability to trim up to 45 caliber and interchange trim chambers. The WFT 2 has a half inch shaft and requires a half inch chuck to drive it. The feature most customers asked for was the ability to interchange trim chambers. Instead of press fitting the trim chambers, like the original WFT, the trim chambers on the WFT 2 are a slight slip fit in bearing with a groove cut for an O-ring which creates a press fit. Changing out trim chambers is accomplished by removing the cutter and pushing out the trim chamber with the knock-out dowel that is provided. Installing the trim chamber is accomplished by setting the trim chamber on a flat surface and steadily pushing the housing onto the trim chamber. Setting the cutter depth is easily adjusted by placing a “master case” in the trim chamber and sliding the cutter up to the case mouth and tightening down the set screws. Trimming is just as precise and clean as with our original trimmer. The trim chamber selection on the WFT 2 is by specific cartridge, but still trims by case family-just order the largest chamber in the family that you intend to trim. This unit and its inserts do not chamfer or deburr the case moouth of the cartridge case as it is trimmed. If you can't find the cartridge you need, please contact our Special Order Department at 800-741-0015
WFT 2 on seuraavan sukupolven WFT-leikkurit. Kaksi tärkeintä parannusta ovat mahdollisuus leikata jopa .45 kaliiperia ja vaihtaa leikkauskammioita. WFT 2:lla on puolen tuuman akseli, ja se vaatii puolen tuuman puristimen käyttöä. Asiakkaat kysyivät eniten leikkauskammioiden vaihtamisen mahdollisuutta. Sen sijaan, että leikkauskammioita painettaisiin paikalleen, kuten alkuperäisessä WFT:ssä, WFT 2:n leikkauskammioissa on pieni liukupinta laakerissa, johon on leikattu uria O-renkaalle, mikä luo painetun istuvuuden. Leikkauskammioiden vaihtaminen tapahtuu poistamalla terä ja työntämällä leikkauskammio ulos mukana tulevalla irrotustapilla. Leikkauskammion asentaminen tapahtuu asettamalla leikkauskammio tasaiselle pinnalle ja työntämällä kotelo tasaisesti leikkauskammion päälle. Leikkuusyvyyden säätäminen on helppoa asettamalla 'master case' leikkauskammioon ja liu'uttamalla terä tapaukselle, sitten kiristämällä asetuspultit. Leikkaaminen on yhtä tarkkaa ja puhdasta kuin alkuperäisellä leikkurillamme. WFT 2:n leikkauskammioiden valinta perustuu tiettyyn patruunaan, mutta se leikkaa edelleen patruunan perheen mukaan - tilaa vain suurin kammio perheestä, jota aiot leikata. Tämä yksikkö ja sen lisäosat eivät viilaa tai poista burria patruunan tapauksesta, kun se leikataan. Jos et löydä tarvitsemaasi patruunaa, ota yhteyttä erikoistilausosastoomme numeroon 800-741-0015.