Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation.
Poista yksinkertaisesti aseen takatähtäin ja vaihda se EGW-kannattimeen, jotta voit asentaa Vortex Viper/Venom-, Burris FastFire- tai Docter-punapiste tähtäimen. Voit poistaa kannattimen ja vaihtaa takatähtäimen milloin tahansa. Asennusmateriaalit mukana. Asennusohjeet Poista takatähtäin* Asenna EGW-kannatin urakoteloon Kiristä säätöruuvi (jos sovellettavissa) Aseta punapiste tähtäin EGW-kannattimelle (pienellä paperipalasella punapiste tähtäimen ja kannattimen väliin helpotat poistamista ja pidät Loctite:n pois punapiste tähtäimeltä.) Levitä sinistä Loctite:a mukana toimitettuihin asennusruuveihin Kiristä asennusruuvit 15in/lbs:iin 2 nappipäistä ruuvia - toimitettu Vortex Viper ja Venom -tähtäimille 2 tasapäistä ruuvia - toimitettu Burris FastFire ja Docter -tähtäimille Mukana olevat ruuvit vaativat 5/64'' kuusiokoloavaimen asennusta varten.