Ominaisuudet
- Asetyyppi: Remington
- Halkaisija: 12 Gauge
- Kapasiteetti: 3-Round
- Malli: 1100,870
- Toimituksen paino: 0,272kg
- Toimituksen korkeus: 36mm
- Toimituksen leveys: 114mm
- Toimituksen pituus: 295mm
Tuotekuvaus
USA:n vientiluvan tyyppi: 0A502
![](/WebRoot/StoreTypes/6.16.3/Store/BO/icons/ico_s_bubblehelp.png)
Tuotenro: 159104873
Valm.nro: 1/4/2007
Jatkomakasiinit Remington 870/1100, Winchester, Mossberg ja Benelli 12 kaliiperin haulikoihin. Saatavilla 2-5 patruunan jatkot. Helppo asentaa, muutostöitä ei tarvita. Kaikissa Choaten jatkomakasiineissa on mukana piipputuki. Jatkomakasiinit Remington 870/1100, Winchester, Mossberg ja Benelli 12 kaliiperin haulikoihin. Saatavilla 2-5 patruunan jatkot. Helppo asentaa, muutostöitä ei tarvita. Kaikissa Choaten jatkomakasiineissa on mukana piipputuki.It is a very nice 870 addition 18.12.2017
Fit and finish are both great. I also found this very nice aluminum magazine / barrel clamp - part # 100-003-182
BCTXX1200 - CLAMP WITH TAC RAIL
at Brownell's that includes a rail section to add a light or laser. Very cool add on for my tactical 870. Looks awesome. As for the factory dimples in the stock mag, a Dremel tool and sandpaper drum made short work of any follower obstructions. The 870 cycles all 6 rounds nice and smooth. Make sure that you stuff a paper towel down the primary mag between the receiver and the dimples before you start grinding, to keep the abrasive crud out if the works. I also put a few small dabs of grease where the paint was ground off. May repaint later. we'll see,
spring sucks, don't buy 18.9.2017
The spring was insanely long and had to be cut down. I cut it down little by little and tried it again after every cut and it still does not work well. The spring is now as short as it can be and still offer some amount of pressure on the follower and it still will not fit the +2 shells that it says it will. It will fit one extra but the spring binds up and does not feed reliably at all. This has been really disappointing. I am going to try to keep the tube itself and find a replacement spring. I will not be buying from this company again. This has been a lot of work trying to fit this thing and it still does not work. It only managed to get 2 stars because it at least looks nice...but looks don't do me any good.
Kohdattiin virhe tämän sisällön lataamisessa. Päivitä sivu jatkaaksesi. Jos ongelma jatkuu, ota yhteyttä asiakaspalveluumme.