OPF-M17, ACRO, RSD is precision machined from 4140 steel, and QPQ coated. Aimpoint ACRO P1/P2 requires the plates to adhere to Aimpoint ACRO TDP with tight tolerances, OPF-M17, ACRO, RSD has proven to be the best choice among professional users. OPF-M17, ACRO, RSD is compatible with MIL issued M17/M18. It is a drop in adapter for superb Aimpoint ACRO sights. It is identical to the Tangodown SSM-03. OPF-M17, ACRO, RSD is compatible with P320 X-Five Legion, Legion Carry, and DP Cut. It is not compatible with P320 Pro Cut, P320 sub compact, AXG, and RX. OPF-M17-ACRO, RSD is shipped with two M4 0.7mm x 6mm (torque value: 20 to 25 in·lb), a T20 key, and a packet of VC-3. Proudly designed and made in the USA. ATTENTION: Steiner MPS users: MPS's recoil lug underneath the sight may vary in width and be slightly wider than that of the ACRO. Should this be the case, firmly push the MPS on the plate, or gently tap on the sight until the MPS fully seats. For the new M17/M18 and SIG P320 with the Delta Point Pro cut, Forward Controls Design is proud to offer OPF-M17, ACRO, RSD (rear sight dovetail).
OPF-M17, ACRO, RSD on tarkkuusjyrsitty 4140-teräksestä ja QPQ-pinnoitettu. Aimpoint ACRO P1/P2 vaatii levyjen noudattavan Aimpoint ACRO TDP:tä tiukoilla toleransseilla, OPF-M17, ACRO, RSD on osoittautunut parhaaksi valinnaksi ammattilaiskäyttäjien keskuudessa. OPF-M17, ACRO, RSD on yhteensopiva MIL:n myöntämien M17/M18:n kanssa. Se on suora adapteri erinomaisille Aimpoint ACRO -kohdistimille. Se on identtinen Tangodown SSM-03:n kanssa. OPF-M17, ACRO, RSD on yhteensopiva P320 X-Five Legionin, Legion Carryn ja DP Cutin kanssa. Se ei ole yhteensopiva P320 Pro Cutin, P320 sub compactin, AXG:n ja RX:n kanssa. OPF-M17-ACRO, RSD toimitetaan kahden M4 0.7mm x 6mm (vääntömomentti: 20–25 in·lb), T20-avaimen ja VC-3-paketin kanssa. Suunniteltu ja valmistettu ylpeydellä Yhdysvalloissa. HUOMIO: Steiner MPS -käyttäjät: MPS:n takaisinlatausluku sightin alla voi vaihdella leveydeltään ja olla hieman leveämpi kuin ACRO. Jos näin on, paina MPS tiukasti levyyn tai napauta kevyesti sightia, kunnes MPS istuu täysin. Uuden M17/M18:n ja SIG P320:n, jossa on Delta Point Pro -leikkaus, kanssa, Forward Controls Design on ylpeä voidessaan tarjota OPF-M17, ACRO, RSD (takasight dovetail).