Korisi on tyhjä.

Ostoskori

Apu ja yhteydenotto

Ilmainen toimitus yli 250€ perustoimituksille

100:n päivän palautusoikeus

Uutiskirje

Tarjoukset

Yli 300 000 asiakasta - kiitämme teitä!

4,93/5 "Erittäin hyvä" (1400+ arvostelua)

Yli 40 000 tuotetta metsästykseen ja ammuntaan

DOUBLE STAR
AR-15/M16 TWANG BUSTER

841348104704 100005392

Stops Annoying Buffer Noise During Recoil

Low-friction Delrin disk fits on the end of the buffer spring, opposite the buffer, and stops the annoying "twang" of the buffer hitting the rear of the receiver extension during recoil. Quick, easy installation, with no permanent alterations to gun. Simply remove buffer and spring, insert Twang Buster, then reinstall buffer and spring.

SPECS: Machined Delrin thermoplastic, black. Fits A2 rifle and M4-style carbine buffer spring/receiver extension tubes.

Lisää...

Pysäyttää Ärsyttävän Puskurin Äänen Rekyylin Aikana

Vähäkitkainen Delrin-levy asetetaan puskurijousen päähän, puskurin vastakkaiseen päähän, ja se pysäyttää ärsyttävän "twang"-äänen, jonka puskuri tekee osuessaan vastaanottimen jatkeputken takaosaan rekyylin aikana. Nopea ja helppo asennus, ei vaadi pysyviä muutoksia aseeseen. Poista vain puskuri ja jousi, aseta Twang Buster paikalleen ja asenna sitten puskuri ja jousi uudelleen.

TEKNISET TIEDOT: Työstetty Delrin-terämuovi, musta. Sopii A2-kiväärin ja M4-tyylisen karbiinin puskurijousen/vastaanottimen jatkeputkiin.

Lisää...

Asiakasarviot: DOUBLE STAR TWANG BUSTER

Arvioiden lukumäärä: 12
Arvostelut brownells.com sivustolla: 12
Arvioiden keskiarvo: 2,9

Not bad (12.8.2010)

Does what it says although it causes bolt catch to malfuntion

works good (27.11.2010)

ive had it for 3 months works and have never had any problems with my rifle.
would def recamend it.

Can be problematic. (17.8.2011)

It does reduce the twang as it says, but in my RRA it reduced the bolt stroke enough that my bold catch would not catch every time. It also caused my bolt to short stroke on occasion and jam the rifle. If you buy this, before installing lock back your bolt and carrier all the way by hand, hold it there and visual check the distance between your bolt face and bolt catch. After installing the buster check that gap again to see if you still have enough to compensate for loads that may not be full power. My RRA went from about a little less than a 1/4" gap to about 10 thousands only. Just thoroughly check function before relying on it.

Meh.. (6.9.2011)

Does stop the annoying twang but it prevented the bolt catch from operating properly on my DPMS AP4. All in all, if you need your bolt catch to work I'd avoid this device, if you don't care about the bolt catch give it a shot.

DO NOT BUY JUNK (5.10.2011)

MADE MY BOLT CATCH INOPERABLE

Ok part (20.12.2011)

It does what it's supposed to do in regards to quieting down the spring noise. But it does have the annoying habit of not letting the bolt lock all the way back after the last round is fired. Not sure if this is due to the combo of running the recoil pad too.
When I installed this I was only using .223 55gr, when I stepped up to 5.56 62gr, the issue was not there as often. I'll use it some more, but we'll see what happens in the next 300+rds.

works well in my 9mm dpms style ar (22.5.2012)

I bought one for my 9mm ar, and it worked perfectly, so I bought several more, and havn't had a single problem. Some of those over-power springs have a few extra coils, so the spring is longer when fully compressed. That may be the problem that others are having. If 1/16 inch piece of plastic is going to prevent your bolt from going all the way back, get a better spring. Those flat wire springs work great! Brownells # 452-000-119WB or 840-000-048WB

It deserves a higher rating. It works. (23.9.2012)

This product does everthing it says and nothing it does not. I install these in every AR I own and it does take the "twang" that all AR's make when fired. Anything to help make the weapon quieter is a good thing. If the "twang doesn't bother you, don't buy it. If you want that sound eliminated completely then I highly recommend it because it does do what it says.

Waste of money. (23.5.2014)

Installed and it did nothing. I removed it, re-read the instructions and re-installed. Still nothing. Changed springs to flat wire JP springs. Still no busting of the twang was going on in my full length A2 stock.

Works (22.10.2014)

Works as it claims. If Your having bolt locking problems in all likelihood your spring is A: too long or B: too stiff or C: A&B.

Had a friend with locking issues & his spring was using wire that was 0.005" thicker than mine. We swapped springs & swapped which rifle had the problem.

Save yer money (18.12.2014)

It's really the spring in the tube of the stock that "twangs" and this does nothing for that - in fact after installing it, the bolt wouldn't lock up manually or after the last shot. Can't return these fast enough.

Does not work as advertised, (22.5.2017)

I purchased the twang buster and installed it my Palmetto State Armory A2 lower buffer assembley. This product does absolutely nothing to reduce the sound of the buffer working, causes the buffer to bottom out too soon- resulting in excess wear on the face of the buffer being smashed by the bolt carrier, and as a kicker, is incredibly difficult to remove once installed. Do not purchase this item. Waste of time, waste of money, causes excess wear on your firearm.

Lue 12 arvostelua lisää brownells.com sivustolla

16.9 16.9 1 EUR

Tuotenro: 100005392
DOUBLE STAR TWANG BUSTER
Valmistajan tuotenumero: JT140 841348104704 Vähäkitkainen Delrin-levy asetetaan puskurijousen päähän, puskurin vastakkaiseen päähän, ja se pysäyttää ärsyttävän "twang"-äänen, jonka puskuri tekee osuessaan vastaanottimen jatkeputken takaosaan rekyylin aikana. Nopea ja helppo asennus, ei vaadi pysyviä muutoksia aseeseen. Poista vain puskuri ja jousi, aseta Twang Buster paikalleen ja asenna sitten puskuri ja jousi uudelleen.

16.9 EUR 4 16,90 € *

Toimitusaika noin 2-4 viikkoa.
4 kpl. USA:n varastossa

Ominaisuudet: Materiaali: Thermoplastic Merkki: AR-15 Väri: Black

Lisää toivelistaan

Kysy tuotteesta

Tiedot

Lisää toivelistaan

Kysy tuotteesta

Top takeaways

Delrin-levy vähentää "twang"-ääntä, joka syntyy puskurin osuessa vastaanottimen jatkeputken takaosaan rekyylin aikana.
Nopea ja helppo asennus ilman pysyviä muutoksia aseeseen.
Sopii A2-kiväärin ja M4-tyylisen karbiinin puskurijousen/vastaanottimen jatkeputkiin.

Ominaisuudet

Materiaali: Thermoplastic Valmistaja: AR-15 Väri: Black Toimituksen paino: 0,005kg Toimituksen leveys: 76mm Toimituksen pituus: 89mm UPC : 841348104704