Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Trijicon RMR red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs The screws that are included with this mount require a 5/64'' allen wrench for installation. This mount does not fits: S&W M&P S&W M&P 2.0 S&W M&P 22
Poista vain takasivun näkyvyys aseestasi ja vaihda se EGW-mountiin, jotta voit kiinnittää Trijicon RMR punapisteen. Voit ottaa mountin pois ja vaihtaa takasivun milloin tahansa. Kiinnitysvarusteet sisältyvät. Asennusohjeet Poista takasivun näkyvyys* Asenna EGW Sight Mount dovetailiin Kiristä säätöruuvi (jos sovellettavissa) Aseta punapistesuunnitelma EGW Sight Mountiin (pienellä paperipalasella punapistesuunnitelman ja mountin väliin asettaminen helpottaa poistamista ja pitää Loctiten punapistesuunnitelmasta eristyksessä.) Levitä sinistä Loctitea annettuihin kiinnitysruuveihin Kiristä kiinnitysruuvit 15in/lbs. Tämä mount vaatii 5/64'' kuusiokoloavainta asennukseen. Tämä mount ei sovi: S&W M&P S&W M&P 2.0 S&W M&P 22