Introducing the Brownells Offset Buffer Retainer - a solution designed to enhance the reliability and longevity of your AR-15's performance during the firing cycle. A common issue for AR-15 builds is a gap between the bolt carrier and recoil buffer. If you’ve ever seen “chatter” marks on a buffer, that is indication there is a gap when the firearm is assembled. This problematic gap between the carrier and buffer leads to the buffer retainer impacted the buffer on every firing cycle, making the chatter marks. This may also mean the bolt carrier is travelling without spring resistance for a short period, or is not getting the full force of the spring to go into battery or to prevent bolt bounce. This “offset” buffer retainer offsets the retention tab forward, allowing the recoil buffer to protrude further forward into the receiver, making full contact with the bolt carrier. Installation is simple, with it being installed much like a standard buffer retainer. The recoil buffer will orient the buffer retainer in the forward position. Machined from 4130 steel and finished with a black oxide finish, the offset buffer retainer will resist corrosion and hold up to intense firing cycles.
Esittelyssä Brownellsin Offset Buffer Retainer - ratkaisu, joka on suunniteltu parantamaan AR-15:n luotettavuutta ja pitkäikäisyyttä laukaisusykli aikana. Yksi yleinen ongelma AR-15 -rakennelmissa on väli vetopultin ja palautusbufferin välillä. Jos olet koskaan nähnyt "chatter"-merkkejä bufferissa, se on merkki siitä, että ase on koottu siten, että väli on olemassa. Tämä ongelmallinen väli carrierin ja bufferin välillä johtaa siihen, että buffer retainer vaikuttaa bufferiin jokaisella laukaisusyklillä, mikä aiheuttaa chatter-merkkejä. Tämä voi myös tarkoittaa, että vetopultti liikkuu ilman jousivastusta lyhyen aikaa, tai se ei saa koko jousivoimaa päästäkseen akkuun tai estääkseen pultin pomppimisen. Tämä "offset" buffer retainer siirtää pidennyslipun eteenpäin, jolloin palautusbufferi ulottuu pidemmälle eteenpäin vastaanottimeen, ja tekee täyden kontaktin vetopultin kanssa. Asentaminen on yksinkertaista, ja se tapahtuu samalla tavalla kuin tavallinen buffer retainer. Palautusbufferi suuntaa buffer retainerin eteenpäin. Koneistettu 4130-teräksestä ja viimeistelty mustalla oksidipinnoitteella, offset buffer retainer kestää korroosiota ja kestää intensiivisiä laukaisusyklejä.